This activity is used to make changes to part groups based on the changes suggested by the engineering service partner for a new IPC document revision. Each suggested change will be displayed specifying the change to be taken on the part group, known as the change set type, as well as criticality of the set. You can select and action a suggested change using one of the following actions:
You can also bulk accept and reject all change sets for a particular change set type, for all the part groups on a change source, at a time. To do so, the change set types must have either the Accept or Spot Check criticality. The initial bulk accept of change sets may take considerable time depending on the number of changes being accepted for the change set type.