Create Part Group
Explanation
This activity is used to create a new part group, generally as a result of
a suggestion to do so originating from an IPC change source, or due to a manual
change deemed necessary for a configuration change source that is not an IPC
document.
Creating a Part Group can be done via,
- Bulk Accept on the Changes Overview
tab in Configuration Change Source details page
- One at a time on the Suggested New Part Groups tab
in Configuration Change Source details page
- Configuration Change Sources page by
selecting/creating the affected change source
- Configuration Change Source details page by
selecting the Create Part Group button
Prerequisites
- Baseline configuration data must be loaded from IFS Maintenix.
- For IPC change sources, the engineering service partner must have uploaded
the document with the suggested changes without upload errors.
- If the part group is being created via bulk accept, the criticality
of the change set type should be Accept or Spot Check.
System Effects
- The new part group is created.