Maintenance Event Sign Off
Explanation
This activity is used to sign off maintenance events (modifications or Life
Limited Part events) included on a work scope. This activity is used when modification
or LLP events in repair shop orders are completed. Since there is no single
status to determine completion of work done on a repair shop order, you have
to look into product status, material status and operation status. If the product
status is Completely Received, material status is Completely Issued,
and operation status is Completely Reported, then the maintenance event
is complete.
However, the maintenance event need not be complete to be signed off.
To sign off a maintenance event, click Sign Off Maintenance Event
in the Work Scope Completion/Mx Event Sign Off tab.
Prerequisites
- Maintenance events on the work scope must be approved and not already
signed off.
- The interim order header has to be in status Partially Released,
Released or Closed.
System Effects
- The maintenance event is signed off and the Signed Off
option is enabled for the record.
- Modification compliance for the assigned part will be updated.
- Modification compliance for any affected parts will be updated if the
value of the Sign Off field is set to Affected
serial marked as complied with for those affected parts.
- The maintenance event in IFS/Fleet and Asset Management will be set
to complete.
- If the execution type on the modification event being signed off is
either Initial Inspection or Continuous Inspection,
the next execution type should be specified.