Non Routine
A non routine is a fault that is discovered during the repair phase of a
scheduled maintenance which needs to be corrected in the ongoing work scope.
In order to repair a non routine fault, it must be reported on the work order
or work task on which it was discovered.
The non routine can be reported with one of the following fault execution
types:
- Report fault - The fault will be repaired
as part of the current work scope.
- Report Partially repaired Fault – This is used to indicate that
some work has already been performed. The time spent by a resource or material
utilized for the work can be reported. In addition, it is possible to enter
condition measurement values if condition measurement requirements have
been defined for the task card. The fault is automatically included in the
work scope and the task cards and subtasks are set to finished if all criteria
are met.
- Report Already repaired Fault - This is used to indicate that
the non routine fault has already been repaired.
Fault Event
A maintenance event is created automatically in IFS/Fleet and Asset Management
when a non routine is reported with either the Report fault
or Report Partially repaired Fault fault execution. The fault event
is added to the maintenance order for the ongoing work scope. If the maintenance
order is distributed with the distribution type,
- Execution Logic Structure - The task cards connected to this
event will be transferred automatically to the relevant work orders based
on the ELOs (execution logic orders) in the execution logic structure defined
on the maintenance order. If a relevant work order does not exist, i.e.,
the ELO is not defined in the execution logic structure on the maintenance
order or the work order for the ELO the task cards are mapped into is already
finished, a new work order will be created automatically and added to the
work order structure.
- Work Order - A new work order is created and the task cards that
are connected to the event will be transferred automatically to this work
order.
A historical work order is generated when the non routine is registered with
the Report Already repaired Fault fault execution.