Perform Condition Measurements
Explanation
This activity is used to record condition measurements on a work task. During
execution of a scheduled maintenance it is possible to find abnormalities, such
as, measurements that are outside the defined condition limits. When such measurements
are found, you can use the functionality described in this activity to record
the new measurements and initiate corrective action. When a measure value that
is outside any of the defined condition limits is recorded, a maintenance event
is created and added automatically to the work package (maintenance order) for
the ongoing work scope.
Note: If condition measurement requirements exist on a work task,
these measurements must be performed before the work task can be completed.
Prerequisites
- The work task must exist in either the Released or Started
status.
- Condition measurement requirements must exist for the work task. The
Condition Measurement Required option must be enabled in the
Execute Work Task page.
- Condition limits must have been defined for the serial connected to
the work task.
System Effects
- Condition measurements are recorded on the Execute work task. This information
can be viewed in the Condition Meas. tab.
- The Condition Measurement Performed option will be enabled in
the Execute Work Task page.
- If the measurement is outside the defined limits, a maintenance event
is generated for it. The event will be added automatically to the maintenance
order for the ongoing work scope.
- The condition measurements reported on the work task will be transferred
automatically to Fleet and Asset Management and a history record will be
generated.