Register Resources for a Task Card or Subtask
Explanation
This activity is used to register resource requirements for a task card or
a subtask.
Resource planning on task cards and subtasks is done on the resource group
level. This means it is possible to plan groups of persons with the required
competency to perform the work and groups of tools or equipment that will be
used during the work. Examples:
- A rail engineer is required to inspect the brake system of a locomotive
and will require a test gauge to check the air pressure.
- A fleet technician is required to perform a landing wheel inspection
on an aircraft, and will require a pressure gauge to check tire pressure.
Resources with following settings can be planned on task cards and subtasks:
- The resource type should either be Person Group or Tool/Equipment
Group.
- The Use in Maintenance option must be enabled for the resource
group.
It is possible to plan multiple person groups and tool/equipment groups on
a task card or subtask.
If a person group is to be used for execution logic grouping, enable the
Use for Execution Logic Grouping option when connecting the
resource to the task card or subtask. Resources marked to be used for execution
logic grouping will be used to generate ELOs (execution logic orders) when grouping
on resources on a maintenance order.
Prerequisites
- A valid task card or subtask must exist.
- Resources with the resource type Person Group or Tool/Equipment
Group that are valid for use in Maintenance must exist. Resources can
be defined in the Resource Groups page.
System Effects
- Resource requirements for a task card or subtask are defined.
- When the maintenance event to which the task card or subtask is connected
is transferred to a work order, a work task is created per task card and
subtask and the resource demand is copied to the task.