Set Affected Parts Not Complete
Explanation
This activity is used to make changes to affected parts after they have been
set to completed. This will enable you to modify the contents of the
Affected Parts
tab in the
Modification
Details page.
To set affected parts not complete, click Set Affected Parts Not
Complete in the Modification Details page
or the Define Modification/Assign Part Revisions tab.
Prerequisites
- The modification must be in the Preliminary status.
- The activity Set Affected
Parts Complete must have been performed earlier.
- IFS/Complex Assembly MRO must be used.
System Effects
- It is now possible to define, remove or change affected parts in
Modification
Details/Affected Parts tab.
- An event message is sent to manufacturing that affected parts now are
marked as not complete. This implies that the work with associating repair
codes to the affected parts should be paused until affected parts again
are set to complete.
- The Affected Parts Completed Date field in the
Assign Part Revisions tab will be cleared.