Configure DOP Settings for Site
Explanation
This activity is used to configure site settings related to dynamic order
processing (DOP).
To perform the activity, enable/disable the relevant
settings on the Site / Manufacturing
page.
In the Planning Settings section on the
General tab:
- Enable Allow MRP explosion for DOP parts if you want MRP
supplies to be generated for all the non-DOP components in the standard
BOM (multilevel) of DOP parts when the DOP parts are planned by master
scheduling.
In the DOP Settings section on the
General tab:
- Enable Auto Close DOP Order if you want DOP orders that meets
the auto close criteria to close automatically .
- Enable Create Purchase Requisition from DOP in Released
Status if you want purchase requisitions created from DOP to be
created in status Released.
- Enable Allow Config Changes for DOP Header with Closed DOP Orders
if you want configuration changes for a DOP header to be allowed
even if the changes affect closed DOP orders.
Prerequisites
N/A
System Effects
Based on the setting configuration, system will behave differently when working
with DOP orders.
If DOP Auto Close DOP Order is enabled, DOP orders that fulfill
the following criteria will be automatically closed:
- The the Qty Complete is equal, or higher than the Order Qty
field on the DOP Order page.
- There are no parts left in temporary inventory (Example: If there were
parts received from a purchase order that were reserved against a DOP order,
the parts would be in temporary inventory).
- All parts for the DOP order must be delivered.
- All child DOP orders must be closed.
If the DOP order immediately under the DOP header is closed, the DOP header
will also be closed.