Action Suggested Changes

Explanation

You may need to make changes to part groups, based on changes suggested by enginnering service partners for a new IPC document revision. Each suggested change will specify the change to be taken on the part group, known as the change set type, as well as criticality of the set. You can select and action a suggested change using one of the following actions:

• Accept
• Reject
• Manually Action

You can also bulk accept and reject all change sets for a particular change set type, for all the part groups on a change source, at a time. To do so, the change set types must have either the Accept or Spot Check criticality. The initial bulk accept of change sets may take considerable time depending on the number of changes being accepted for the change set type.

Prerequisites

• The affected part groups must exist.
• The change sets are in the Pending status.
• The status of the IPC document revision must be InProgress.

System Effects

•  If you have accepted or rejected all change sets in one go for a particular change set type, for all the part groups on a change source, the change source becomes the active change source on the part groups. The status of the change sets is Accepted or Rejected, depending on the bulk action taken.
• With actioning change sets individally, the status of the change set is updated to Accepted, Rejected or Manually Actioned.

Pages

Configuration Change Sources
Part Group

Activity Diagrams

Update Configuration Baseline