Inspection results can be entered for inventory registered purchase parts, non-inventory registered purchase parts, and no-number parts. This must be done when the quantity to inspect is larger than zero (0). For inventory parts, you must enter the inspection results before you are allowed to move the parts into a stock location. For non-inventory parts or no-number parts, the results must be entered to complete the receipt. Use of serial numbers affect the handling.
You can enter the inspection results via the Receipt page (and some related places) or the Inspection Management page. Both pages lead to the same dialog. Inspection results can be reported, regardless of the parts' location, i.e., in an arrival, inspection, or stock location.
If you are using IFS/Quality Management and have created an analysis, tested the parts in question, and reported the results in this component, you can use these results as a guideline when you enter the inspection results and return parts for rework, in the receipt function.
When you enter the inspection results, faulty parts can be returned for rework. The return cause can, for example, be problems with the quality. The financial burden of returned parts is placed on the supplier, i.e., the parts need to be reworked. When parts are returned for modification, they are counted as a backorder; you can do arrival registration after the modification is done.
A return for rework is normally entered per return cause in the appropriate place when entering the inspection results. You can specify several return causes for a receipt line. Do this by entering one line for each return cause. Example: You have a receipt line with ten parts. Six parts are entered as approved, one part is returned by the return cause A on one line, and three parts are returned by the return cause B on a second line. To make a full report, the sum of the quantity approved and any quantities scrapped or returned should be the same as the quantity to inspect. Otherwise, you have done a partial report of the inspection results.
When you are returning several lines with the same return cause on a receipt line, such as serial numbered parts, it is time-consuming to enter a new line and specify the return cause for each serial number. Instead, you can select all lines in question in Receipt/Details tab and specify the return cause in advance by clicking Return Receipt Lines. A dialog opens and you can specify a return cause for all selected lines. You also must choose the return type Return Rework. When this is completed, the dialog for entering the inspection result opens with the return cause specified per serial number already filled in in the proper place. You can remove a line that is selected by mistake. It is also possible to change the return cause on a single line.
Once you perform the return, the parts will be included in a new shipment or an existing shipment to the same supplier if the status is not Complete. Adding of the purchase receipt return line to a shipment will depend on the Shipment type mentioned in the supplier's default delivery address, Outbound Address Information.
If you, for some reason have planned returns to a supplier by mistake, you can undo this action from the Receipt/Return tab before attaching the shipment to a shipment or after releasing the line from the shipment. The shipment lines for which are not delivered but report picked, you can undo this action from Inventory Parts in Shipment Inventory page. If you would like to undo this action after the delivery of the shipment, you can do this through Undo Inspection Results for Inventory Part and Undo Inspection Results for Non-Inventory Part pages.
Note: Rentals cannot be returned as rework/credit and/or scrap during purchase order inspection.