Copy Operational Parameter Information from a Maintenance Group
Explanation
Use this activity to copy operational parameter information from a maintenance
group of a serial part to another maintenance group. Note: You can only
copy primary operational parameter information.
Prerequisites
- Maintenance groups must be defined for the serial part.
- A primary operational parameter must have been entered for the serial
part before a maintenance group can be entered, and before operational parameter
information can be copied.
System Effects
- Operational parameter information will be copied to the selected maintenance
group.
- You can register operational log data for all serials belonging to a
registered part number and maintenance group.
- The Maintenance Group that have been defined after operational parameters
have been defined for a serial part, will automatically receive all defined
operational parameters.
- An operational parameter for a maintenance group cannot be removed if
serials defined for the part number and maintenance group have operational
log entries.
- The operational parameter sequence decides in which order the operational
parameters are measured when operational log data is entered.