Receive Multilevel Repair Shop Order

Explanation

You can receive the repaired part into the inventory from a multilevel repair shop order.

This activity requires that a shop order product exists ready to be received.
Parent parts must have been completely issued.
All the serial tracked components must have been completely issued and other components must be at least reserved.

This activity results in the parent part being received into the inventory.
The following changes take place in the old as-built structure data.
- If any component is salvaged (due to a remove or replace repair action) in the repair, then those component quantities will be marked in the old as-built structure as removed.
- If any component (that exists in the old as-built structure) is added in the new as-built structure, then it will also be marked in the old as-built structure as removed.
A new as-built structure is created as follows:
- If the parent part is lot/batch-tracking-enabled, then the lot batch number reserved in the shop order is used for each of the lot/batch-tracking-enabled components.
- As-built revision is incremented by 1 for all the serial-tracked parent parts.
- Any of the structure components along with their sub assemblies are excluded if they have been defined as Remove, Replace, Not Present, or Salvage.
- All the components added through Add, Replace, Install and repair actions are included. Exception: Components added with Add as the repair action and Exclude from As-Built structure enabled will not be added to the new as-built structure.
- If there were structure changes defined, then the part revision is saved for parent parts as given.
You can view the new as-built structure created on the As-Built Structure page.