Copy Complete Structure from DOP with Same Configuration
Explanation
This activity is used to copy a DOP structure from another with the same configuration.
This is done using the Create DOP Structure/Routing
dialog. To access the dialog click Create Structure and
then Create DOP Structure. In the Create DOP
Structure/Routing dialog select Copy DOP Structure/Routing
from other DOP. In the Create DOP Structure/Routing
from other DOP section select the DOP ID and the DOP order ID
for the structure you want to copy. You will only be able to choose among
those DOPs that have the same configuration as the one you are copying to.
Prerequisites
- The DOP header part must be configured and have a configuration attached.
- The DOP
header must be in status Created.
- An interim order structure must not exist for the DOP header.
System Effects
- DOP orders are created with a quantity and in a structure as a copy
of another DOP structure.
- The status of the DOP orders will be Unreleased unless Auto Release
has been enabled in the Settings
section on the Details tab on the DOP Header
page. In that case, the status will be Released. Releasing a DOP
order means generating a shop order or a purchase requisition for the
DOP order.
- When releasing pegged project specific DOP orders, the system will generate
project specific shop orders or purchase requisitions/purchase orders dependent
on the part type. These orders will be received into project inventory.
- A valid routing revision and buildable routing alternate will
be added for each DOP order. If no buildable or plannable routing alternate
exist for the part a DOP log is created, but the creation of the structure
will continue. If the routing is serial effective
and no serial numbers
are reserved for the DOP order a DOP log is created, but the creation of
the structure will continue.
- The due date and the start date are calculated for each DOP order in
the structure, depending on due date and start date of the parent DOP order,
lead-time and lead-time offset, where the lead-time is depending on lot
size and routing revision and alternate. These lead-times will be calculated
based on the manufacturing calendar, whereas the pegged purchases will
use the distribution calendar.