Add Part Requirement

Explanation

When working on a task or fault, you might need to use parts to complete your work.

You can add parts for a task on the Task Details page, and for a fault on the Fault Details page.

Prerequisites

• A task must exist in the Active or In Work status.
• A fault must exist in the Open or Deferred status.
• Basic data for parts, part groups, aircraft systems and subsystems must have been defined before.

System Effects

• A part added to a task or a fault can be viewed from the Task Details or Fault Details pages respectively.
•  If the added part is a tracked, serial or repairable batch part, both part removal and part installation records are created. If the added part is a non-repairable batch part, a part installation record is created.
•  Part installation and part removal records can be viewed on the Part Changes tab of the mobile application, and the Part Installations and Part Removals tabs of the web application.

Procedure - Add a part

You can perform this procedure online or offline. For faster part search results, perform this online. 

1. Open the Task Details or Fault Details page and select Add Part.
2. Select the Part field and enter the partial or full part number. If required, sort your search results by the Sort by field. 
3. Select the part.
4. Specify part details:
   1. If the part is a batch part, change the default quantity.
   2. If the part belongs to multiple part groups, select the part group from which the part should be issued.
   3. If the part is part of an assembly that has multiple positions, select the assembly position.
   4. If the part is for a configuration slot with multiple positions, select the position.
5. Select Finish.

If the part change has not been signed off, you can remove the part requirement.