Configure DOP Settings for Site
Explanation
This activity is used to configure site settings related to dynamic order processing (DOP).
To perform the activity, enable/disable the relevant settings on the Site /
Manufacturing page.
In the Planning Settings section on the General tab:
- Enable Allow MRP explosion for DOP parts if you want MRP supplies to be generated for all the non-DOP
components in the standard BOM (multilevel) of DOP parts when the DOP parts are planned by master
scheduling.
In the DOP Settings section on the General tab:
- Enable Auto Close DOP Order if you want DOP orders that meets the auto close criteria to close
automatically .
- Enable Create Purchase Requisition from DOP in Released Status if you want purchase requisitions
created from DOP to be created in status Released.
- Enable Allow Config Changes for DOP Header with Closed DOP Orders if you want configuration changes
for a DOP header to be allowed even if the changes affect closed DOP orders.
Prerequisites
N/A
System Effects
Based on the setting configuration, system will behave differently when working with DOP orders.
If DOP Auto Close DOP Order is enabled, DOP orders that fulfill the following criteria will be
automatically closed:
- The the Qty Complete is equal, or higher than the Order Qty field on the DOP
Order page.
- There are no parts left in temporary inventory (Example: If there were parts received from a purchase order
that were reserved against a DOP order, the parts would be in temporary inventory).
- All parts for the DOP order must be delivered.
- All child DOP orders must be closed.
If the DOP order immediately under the DOP header is closed, the DOP header will also be closed.