Set Affected Parts Not Complete
Explanation
This activity is used to make changes to affected parts after they have been set to completed. This will enable
you to modify the contents of the Affected Parts tab in the Modification Details page.
To set affected parts not complete, click Set Affected Parts Not Complete in the
Modification Details page or the Define Modification/Assign Part
Revisions tab.
Prerequisites
- The modification must be in the Preliminary status.
- The activity Set Affected Parts Complete must have been
performed earlier.
- IFS/Complex Assembly MRO must be used.
System Effects
- It is now possible to define, remove or change affected parts in Modification Details/Affected Parts
tab.
- An event message is sent to manufacturing that affected parts now are marked as not complete. This implies
that the work with associating repair codes to the affected parts should be paused until affected parts again are
set to complete.
- The Affected Parts Completed Date field in the Assign Part Revisions tab will be cleared.