Cancel Analysis Results
Explanation
This activity is used to cancel the data points that are not needed in the analysis result. You can select more
than one data point at a time.
To cancel a data point that is not needed in the analysis from:
- Analysis Result page. Click Cancel Data Point in the Analysis
Result Lines section, enter a cancellation reason and click OK.
To cancel all uncompleted data points click Cancel Uncompleted Data Points, enter a cancellation
reason and click OK.
- Shop Floor Workbench page. Select the operation and click Operation Guide, then click
Cancel in the Control Plan Inspections section for the relevant control plan line.
It is possible to close and confirm an analysis with canceled data points. However, the canceled data points
will not be included when you create SPC charts or calculate capability indices.
Prerequisites
- The data point must have the Uncompleted status.
- A reason for cancellation must have been defined on the Cancel Reasons page.
System Effects
As a result of this activity:
- The data points will be canceled, and the status of the data points will be set to
Cancelled. It is not possible to update a data point after cancellation.
- If all data points for an analysis result are cancelled the status of the analysis result will be set to
Cancelled.