Enter Measurement in Mobile

Explanation

Use this activity to enter the measurement readings obtained for an object. A measurement is carried out on a parameter that has previously been defined for the object.

Measurement Parameterscan be accessed from Measurements action in Object detail page.

Use the New action on Measurement Parameter record to enter a new measurement. In this assistant, you can register either the FULL or DELTA reading value on Accumulated type parameters. For Limit and Condition type parameters, you can enter New Reading Value and New Condition Rating respectively.

By navigating to Report All page, you can register measurements on multiple Test Points/Parameters at the same time for the object.  For accumulated parameters, you can register only New (Full) Reading values in this page. Select the button Report Delta Values in the header to report DELTA values for these parameters.

Prerequisites

• A test point and a parameter must have been connected to the object on the Serial Object/ Functional Object or Service Object page in IFS/Equipment.

System Effects

• Measurement History of the object parameter is updated with the last measured value.
• If delta value is recorded, it is added to the previous Recorded Reading and the new Recorded Value and Total Value are calculated.
• If the measured value fails validation, the measurement is still saved, but with the Preliminary Reading measurement type and readings added after the measurement continue to record as measurement type Preliminary Reading.
• If the measured value of a limit parameter which has Minimum/Maximum reading thresholds defined or condition parameter which has Maximum reading thresholds defined, falls out of the thresholds, a warning message is given.
• If this particular object has been defined as Update from Object (Master) on the Testpoint/Parameter level of another object (Child) and setup for measurement inheritance, the child will inherit the corresponding delta value on the master for an accumulated type parameter and the full value for a limit type parameter.  These inherited measurements will then be synched to mobile.
• If a measured value is entered for a parameter on a child object, which has been set up to inherit measurements from a master, a warning message is given.