Perform Condition Measurements
Explanation
This activity is used to record condition measurements on a work task. During execution of a scheduled
maintenance it is possible to find abnormalities, such as, measurements that are outside the defined condition
limits. When such measurements are found, you can use the functionality described in this activity to record the
new measurements and initiate corrective action. When a measure value that is outside any of the defined condition
limits is recorded, a maintenance event is created and added automatically to the work package (maintenance order)
for the ongoing work scope.
Note: If condition measurement requirements exist on a work task, these measurements must be performed
before the work task can be completed.
Prerequisites
- The work task must exist in either the Released or Started status.
- Condition measurement requirements must exist for the work task. The Condition Measurement Required
option must be enabled in the Execute Work Task page.
- Condition limits must have been defined for the serial connected to the work task.
System Effects
- Condition measurements are recorded on the Execute work task. This information can be viewed in the
Condition Meas. tab.
- The Condition Measurement Performed option will be enabled in the Execute Work
Task page.
- If the measurement is outside the defined limits, a maintenance event is generated for it. The event will be
added automatically to the maintenance order for the ongoing work scope.
- The condition measurements reported on the work task will be transferred automatically to Fleet and Asset
Management and a history record will be generated.