Enter Manufactured Inventory Part, Main
Explanation
The procedure below is the first of a number of procedures that might be needed in order to initiate and later
on, complete the registration of a manufactured inventory part on the Inventory Part page. I.e., an
inventory part with one of the below Part Type values:
- Manufactured: A traditional manufactured part with a product structure or configuration
structure.
- Manufactured Recipe: A manufactured part with a recipe structure which allows entering
components by weight and volume.
- Remanufactured: A part restored to a like-new condition using a remanufacturing structure
type.
- Disassembly Component: A part produced during the disassembly of a product.
- By-Product: A part that is received as an unintentional secondary product from the
production process of the main product.
- Co-Product: A part that is received as an intentional secondary product produced
simultaneously with the main product.
Prerequisites
- A planner must be entered on the Inventory Part Planners page.
- The unit of measure must be defined on the Unit of Measure page.
- If the part should be entered on a site other than the default one, this site must be connected to your user
ID. This is done on the Sites per User page.
- If commodity groups are to be used, they must be defined on the Commodity Groups page.
- Asset classes must be defined on the Inventory Part Asset Classes page.
- Part Status must be defined on the Inventory Part Status page.
- ABC-Code must be defined on the ABC Classes page.
- Safety Code, if applicable, must be defined on the Safety Instructions page.
- Accounting Group, if applicable, must be defined on the Inventory Part Accounting Groups page.
- Product Code, if applicable, must be defined on the Inventory Part Product Codes page.
- Product Family, if applicable, must be defined on the Inventory Part Product Families page.
- For the inventory part to inherit warranty data, the warranty data must first be entered for the
Part.
System Effects
The initial mandatory information for an inventory part with Lead Time Code set to
Manufactured is entered into the system.
When the inventory part is created, it inherits any default warranty types defined for the part catalog
part.
It is now possible for you to make entries with this inventory part throughout the system.