Copy Operational Parameter Information from a Maintenance Group
Explanation
Use this activity to copy operational parameter information from a maintenance group of a serial part to another
maintenance group. Note: You can only copy primary operational parameter information.
Prerequisites
- Maintenance groups must be defined for the serial part.
- A primary operational parameter must have been entered for the serial part before a maintenance group can be
entered, and before operational parameter information can be copied.
System Effects
- Operational parameter information will be copied to the selected maintenance group.
- You can register operational log data for all serials belonging to a registered part number and maintenance
group.
- The Maintenance Group that have been defined after operational parameters have been defined for a serial
part, will automatically receive all defined operational parameters.
- An operational parameter for a maintenance group cannot be removed if serials defined for the part number and
maintenance group have operational log entries.
- The operational parameter sequence decides in which order the operational parameters are measured when
operational log data is entered.