Modify Task Cards for Fault
Explanation
This activity is used to modify the task cards that are connected to a fault. These are the task cards that will
be executed when the fault is repaired.
When a fault is reported, the standard task cards which are connected to the given product model and fault
function will be copied to the fault. One or more of these standard task cards may not be applicable for the repair
of a particular fault and therefore can be removed from the fault using this activity. Furthermore, if needed, you
can add new task cards to the fault. Note: You can only add the task cards that are defined for the part
revision of the serial on which the fault was reported.
When a fault is distributed to a work order, the task cards, subtasks, resources, and material which are entered
on the fault will be transferred to the work order. A work task is created for each task card or subtask. If a new
task card is added to the fault after the creation of the work order, a work task will be added for this task
card.
To perform this activity, search for the relevant fault number and the part or serial on which the fault was
reported from the Manage Fault Information page.
- Create a new record in the Task Cards tab to add a new task card to the fault.
- To remove a standard task card from the fault, select the row that holds the task card to be removed, and
click Delete.
- Select the Reset to Standard Task Cards option to update the existing task card list by
using the Reset to Standard Task Cards dialog. If you want to remove previously generated
task card records (and thereby add new task cards to the serial fault) enable the Remove Generated Records
option, and if you want to remove all task card records that were manually added to the fault, enable the
Remove Manual Records option.
Prerequisites
- Task cards must have been connected to the product model and fault function. For more information refer to
the activity Define where Task Cards should
be used.
- Task cards must exist for the part number/revision of the serial on which the fault is reported.
- If the fault is connected to a maintenance order, and is in the Incomplete status or a higher status,
it is not be possible to modify the task cards of the fault. Instead, you need to add or remove (cancel) task
cards for the fault event directly on the maintenance order.
System Effects
- Standard task cards are copied to the fault and modified according to the required repair actions for the
fault.
- New task cards are added to the fault.