Cancel Analysis Results
Explanation
This activity is used to cancel the data points that are not needed in the analysis result. You can select more
than one data point at a time.
To cancel a data point that is not needed in the analysis:
- From Analysis Result page: Click Cancel Data Point in the Analysis
Result Lines section, enter a cancelation reason and click OK. To
cancel all uncompleted data points click Cancel Uncompleted Data Points, enter a cancellation
reason, and click OK.
- From Shop Floor Workbench page: Select the operation and click Operation Guide, then
click Cancel in the Control Plan Inspections section for the relevant control plan line.
It is possible to close and confirm an analysis with canceled data points. However, canceled data points will
not be included when you create SPC charts or calculate capability indices.
Prerequisites
- The data point must have the Uncompleted status.
- A reason for cancelation must have been defined on the Cancel Reasons page.
System Effects
As a result of this activity:
- The data points will be canceled, and the status of the data points will be set to
Cancelled. It is not possible to update a data point after cancelation.
- If all data points for an analysis result are canceled, the status of the analysis result will be set to
Cancelled.
- If the analysis result is associated with a First Article Inspection, Cancelled data point
result values are excluded from the Characteristic Accountability data.