Remove Part Requirement

Explanation

A part requirement that is no longer needed should be removed so that material is not sourced or issued against it. Use this activity to remove an unissued part requirement from a task or fault, or to reverse a part that has already been issued before its requirement is removed.

The requirement is removed from the Material tab of the Task Details or Fault Details page. There is no separate cancel command. An unissued line is taken out with Remove, and an issued line is first reversed with Unissue Confirmation before it can be removed. An unsigned part installation or removal record can also be removed.

A KIT line cannot be removed once its INKIT sub-components are signed. Closing the requisition header is a separate material-controller action on the Maintenance Material Requisition page and is not part of removing the requirement. To add a requirement, see Add Part Requirement.

Prerequisites

Procedure

Remove an unissued requirement

Navigate to the Task Details or Fault Details page.

  1. Open the Material tab.
  2. Select the part requirement.
  3. Select Remove.
  4. Confirm if prompted.
  5. Verify the requirement no longer appears on the task or fault.

Remove an issued part

  1. Select Unissue Confirmation to reverse the issued part.
  2. When the line is unissued and eligible, select Remove.

System Effects