Report Condition Measurement

Explanation

This activity is used to manually record condition measurements for a serial. If the registered measurement is outside the defined condition limits, you will receive a warning. A pending maintenance event is created. A new cycle of measurement is started after the event is completed.

This activity can be performed using Condition Measurements tab in Report Condition Measurement page. To report measurement results related to daily operations for an aircraft, use Condition Measurements tab in Flight Log page.

Note: Enter the measured value of the condition in the Measure Value field. Note that the previous measurement appears by default and must be overwritten with the new measure value. Enter the date on which the condition measurement was completed in the Measure Date field, The default value is set to today's date (i.e., system date) but can be changed.

Prerequisites

• Condition limits must have been defined. For more information, refer to the activity Define Condition Limits per Part Revision.
• If measurements are to be reported on a flight log for a vehicle or a serial in its structure, the flight log must be in the Open status.

System Effects 

• When recording the condition measurement, a maintenance event is generated if the measured value exceeds the warning or danger limits.
• A maintenance event is also generated if the change from the last measurement is greater than the defined change limit.

Pages

Flight Log
Report Condition Measurement

Activity Diagrams

Make Operational Entry
Manage Flight Logs