About Pool Selection Rules

Pool Selection Rules are Contractor Selection Rules that treat eligible contractors as an equivalent group. Instead of naming one contractor or ranking contractors by performance, a Pool rule first decides who is eligible, then uses a Distribution Model to share work fairly or offer it to everyone at once.

For an overview of all selection modes, see About Contractor Selection Rules.

When to use a Pool rule

Use Selection Mode Pool when several contractors can perform the same type of work under similar commercial and operational conditions, and ranking would add complexity without improving the outcome.

How the pool is built

When work is released and an active Pool rule matches, the eligible pool is resolved as follows:

  1. Contractors that match the rule criteria are included. Typical criteria are Service or Service Type, Region, Service Organization, Urgency, Customer, and Contractor Tier.
  2. Manual Include overrides add a contractor even if they don’t currently match the criteria.
  3. Manual Exclude overrides remove a contractor even if they match the criteria.

You can set a Contractor Agreement line for contractors in the pool. Review the calculated pool on the Contractor Selection Rule to see who is included and whether they were added by the rule or by a manual override. Includes and excludes apply only to that rule.

If Contractor Tier is set on the Rule Matching tab, only contractors in the selected tier are eligible. If tier is blank, tier doesn’t restrict the pool.

Distribution models

The Distribution Model on the rule decides how work is offered across the pool. Distribution defines fairness — not who is “best.” No performance score or preference ranking is applied.

Distribution Model Behavior
Round-Robin One contractor is awarded. The next matching job from this rule goes to the next contractor in the pool, then the next, wrapping back to the start. Sharing is tracked per rule.
Least-Recent One contractor is awarded: the contractor in the pool who has waited the longest since they last received work from this rule. If nobody in the pool has received work yet, a consistent order is used.
Broadcast to All Every contractor in the pool receives an independent Contractor Order in Offered status at the same time. The first contractor to accept is awarded the work. Remaining offers are set to Expired.

Acceptance and expiry

Acceptance Period on the rule still applies to Pool orders, with different outcomes by distribution model:

Capacity

If Consider Capacity is enabled on the rule, contractors who have reached their weekly job limit for the relevant Service or Service Type are left out of the pool. For Broadcast to All, capacity is consumed when a contractor accepts (when the work is awarded), not when the offer is sent. See About Contractor Capacity Control.

Related activities